Michael Z. Williamson
Rock River Arms PDS Piston Driven Carbine- Review

  • Rock River Arms PDS Piston Driven Carbine

    Rock River Arms
    Review Date
    May 2011

    The PDS is Rock River Arms' entry into the piston AR market. I've never been enthusiastic about this concept, but Rock River put some serious design thought into this weapon, and the results are impressive.

    Starting at the rear, it has a side-folding stock, because the recoil system isn't in a receiver extension inside it. This is a significant advantage for transport and carry. The folder mechanism does take a bit of getting used to. It requires lifting the stock out of a deep detent. It locks solidly in place open or closed, and has a 6 position stock. As the stock tube is not needed for a recoil mechanism, it contains a storage section with a threaded cap, big enough to take a rod, cleaning tools, and small maintenance tools and spare parts. This is a big plus for a gun that sees real use.

    The two stage proprietary trigger is crisp and reliable. The test gun broke cleanly at about 6 lbs. It was very consistent and comfortable. The major difference on the controls is that the charging handle is a forward type, like the German H&K G3. It is ambidextrous, non-reciprocating, and folds flat on closing. It is reliable, but does take a bit of strength to work. Smaller shooters and females had trouble, but could manage with effort. The grip is a Hogue model, with good texture.

    Takedown starts as with any AR, and once the receiver halves are open, the recoil mechanism is pulled down and out. This removes the operating rod, bolt carrier and bolt in one unit. It's elegantly simple.

    The receiver top is elevated slightly over standard ARs, because it contains the recoil mechanism. This puts it at a very comfortable height for most sighting systems - a riser is not needed. It is a monolithic rail for mounting sequenced optics.

    The handguard is a bit odd looking and feeling, but very solidly mounted and useful. There is also an optional railed handguard.

    The gas system has two settings, and the operator is cautioned not to use a suppressor with this weapon. A different gas block is in production for that purpose. Recoil is somewhat brisker than a gas impingement system due to the greater operating mass, but is not uncomfortable. The bottom of the gas block includes a 1" rail for accessory mounting. The gas block is very solidly mounted. I did not attempt to dismount it to examine it. Generally, pins are preferred to screws, but as it does not protrude far, and does not mount a bayonet, the heavy construction and machine screws are plenty.

    We tested using several brands of ammunition, with an Aimpoint sight mounted, shooting over a sandbag. All the major commercial brands remained under 2.5" at 100 yards, in 10 shot groups. Best group was 1.55". Weather was 50 degrees F, 75% humidity, still air, at approximately 300 feet elevation. Keep in mind, this was with combat optics and sandbag, not a mounted weapon and scope.

    The only stoppage was a double feed, attributed to a bad magazine, as the same problem occurred with another gun with that magazine. After 500 rounds, the mechanism was clean, and the bore only needed a pull through with a Boresnake for cleaning. That's certainly a big plus. The receiver remained cool, and there was very little oil evaporation.

    The PDS comes with a magazine, a simple to read instruction manual, and a hard case. MSRP is $1685 as tested, which makes it only slightly pricier than a high-end standard AR.

  • All Reviews